Interested to Buy Any Domain ? << Click Here >> for more details...
what is the Analog signal and what is the Digital signal
- 4 Answers
- 7732 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoj
Analogue signal is in any wave form which varies as time graph changes
digital signal is in data form ie ON or OFF state in other words it is in 0 and 1 state
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Name different types of bourdon tubes.
Exothermic reaction./ endothermic reaction
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
Please asked me How calculate DCS controller memory.
Is there any relation between Artificial Intelligence and Instrumentation?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
i need some objective type questions in instrumentation
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
why I need valve guard and whats different between guard and positioner ??
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
what is dc moter.
