What is the difference between voltage transformer and
potential transformer?
Answer Posted / suri
CT secondary side should be closed whereas in PT may be open
or closed.
CT should connected in series with the line and PT should
connected across the lines.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why output is out of phase in case of common emitter?
how many parameters can integrate with fire alarm basically ?
What is an alternator impedance value?
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
what is difference between line differential and transformer differential?
What is the purpose of using busbar mounting fuse?
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
what is (+) and (-) in generator field detector stand for?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
Why should we hire you over the others waiting to be interview?
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
why we have and use 3 phase not 2 or 4 or other in power system?