Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / n reddy
to calculate the short circuit current,copper
losses,impedance ,MVA rating,type of fault & impedance also.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
reason of diode failure in alternator
what is load vs Torque curve & why it is used?
What is precision of a measurement?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
How Self works in DG set
how can we find thae value of capacitor for single phase motor. what is difference between starting capacitor and running capacitor.
what is buffer resistance starter.?.What is the working principle and where it is used..?
how can motor both beasrings insulation resistance can be check?
What is the disadvantage in proportional controller?
