I want to measure bidirectional steam flow? Kindly suggest
me a suitable flow meter. steam is superheated at 41kg/cm2,
350°C

Answer Posted / umair naz mughal

i think u did not use a ultra sonic flow meter because it leaves it indican for some time u should be use a D.P transmitter.

Is This Answer Correct ?    2 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

Hi Friends i am going to write BARC written test by this month 20th (20-5-2008). So please if any body knows the details about this or having previous question papers pls mail me to kkumarei@gmail.com. For Suggestions give one message to 9962122264

1986


what will the sending unit in the fuel gauge utilizes?

1469


What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.

2503


There are many type of control cable like pair,core,tried, What are defination each one

1740


What is 3 selection available when configure the burnout protection for controller

2074






Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell

743


if in a level tx height is given, how u calculate the ranges of the tx?

6413


Difference between ultra sonic flow meter

1557


use of split range ? where it is used ? in which control loop it is used ?

1486


How does a single acting, spring return ball valve actually work? Does it require continuous air supply? 

1679


why using negative supply for bentley nevada vibration system ?

1713


What is zener diode? What is voltage regulator?

641


hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel

1520


how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

1717


What are the types of control valves available

1533