Interested to Buy Any Domain ? << Click Here >> for more details...
why select the 3 phase power supply system in electrical system.
- 3 Answers
- 7724 Views
- RSE, Yamaha, I also Faced
- E-Mail Answers
Answer Posted / raghavendra
basically power is required for each and every appliance we use like motors ,fans,ac,tv's,fridges etc.for each and every load there should be different type of supply . the three phase supply increases the efficiency of single phase supply by 50 percentage .but further increase in phase like six phase increases the efficiency by only 7 percent only and also leading to more complications on the generator side , and further increase in phases also leads to same case increasing the complexity on generator . so 3 phase supply includes 3 phase double circuit supply ,3 phased 3 circuit supply and so on........................
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
What is meant by time harmonics and space harmonics?
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
how the characterstics of control valve being done
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
what is the purpose of high speed earth switch in gas insulated substat
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
what are the application of over current relay?
What is use of starter and choke in tube light
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
what is the condition for YnD11
What is size 00, 01, 1 etc., in HRC fuse types?
where does 22kv line starts
how to build a network which step down 415v to 1v rms
what mean by analog ,digital,numerical meters and relays? say the example?
