Answer Posted / dipen
FOR DCS THE PROGRAMMING LANGUAGE IS CL ( CONTROL LOGIC).
DCS PROGRAMMING AND COMMUNICATION IS BASED ON THIS CL. EACH AND EVERY SECTION HAS ITS OWN CL BASED ON PROCESS REQUIREMENTS.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Any body have know try work calculation ???
flow transmitter formula?
Why grounding is necessary? Give example with diagram.
What is difference between differential pressure & delta pressure?
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
how many type conductivity sensor ?
what is the imbustion control loop
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
What is the difference between PLC and DDC?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
How ejector(or)evactor air pump is working in thermal power plant?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
why we are not using the turbine flow meter in the steam service?
what is the criteria to decide conductor size of a cable ?
What are primary elements of measuring pressure?
