Answer Posted / baranidharan. s
It is an Electronic device. It is used to convert the
instruction or data into a codes. It is also used to
transfer the compressed videos, and pictures. And the
encoded input data is to be decoded by the decoder. That
means get a original input data.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
Is there any specialised book to refer about fault level calculation both in MV and LV side??
The series field winding has low resistance while the shunt field winding has high resistance. Why?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
what is PDU in transformer?? which company manufacture??
What is conventional thermal current (Ith)
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
List of equipments required foe industrial repair lab.
is it possible to start a motor in felid connected to a remote mcc
When we need up only in o/p 440v, so why we use directly in 11kva in input?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
how can we change the phase angle b/w two phase?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
why using transformer and thyristor switch in 3 phase apfc panel
How to convert a two phase power into a three phase power in induction machine?
