Hi ,what the accurate method to set correct(In) over load to
protect the 3~ motor
- 4 Answers
- 3609 Views
- I also Faced
- E-Mail Answers
Answer Posted / pundlik wanwe
For calculation of thermal over load current setting following formula is used
OLR = Motor FL current/ CT Ratio X 105%
Normally it is set at 105 %
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
State the other types of Air Conditioners?
What are two contours of nichols chart?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
how we explain parallel paths armature winding?
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
What are marginally stable systems?
What is electrical cable termination
What are locations arc protection relay is fixed.
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
What happens if we connect a single phase energy meter in reverse polarity.
what is the breaking capacity and making capacity of circuit breaker and how
What is the unit of charge and current?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
could you measure current in parallel?
What is the test block protection relay if any body know plz explained
