Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raj
relay are device which are use to sense fault .
and cntactor are device which reacived signal through relay
and remove contact from the line or connect the line
(manually)
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
how can i improve the power factor in domestic (230v)
I need HT sphere gap calibration table. Can any body help me.
Do inductive loads have distorted current waveforms ?
What is the working principle of servo motor? And explain it.
the typical output of a solar cell is........
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
difine electrical ballast in HPSVL
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
PLZ EXPLAIN THE INTERLOCKING AND CONTROLLING OF CONTACTORS????HOW CAN I DO THAT?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
what & how to check the lightning arrester
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
What is the type of earth fault protection used in battery? explain.
