Interested to Buy Any Domain ? << Click Here >> for more details...
Name some of the common protocol use in automation.
- 3 Answers
- 6326 Views
- Empower, I also Faced
- E-Mail Answers
Answer Posted / vaseekaran ganeshan
PROFIBUS (PA & DP)
MODBUS
FIBRE OPTIC COMMUNICATION
ETHERNET
OPC
HART COMMUNICATION.
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Explain pH, Conductivity.
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
please send data bank of quetions answers on analytical instrumentation.
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
What is the PLC configuration in Cement industry?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
How the sizing of the analog signal cable is calculate?
What is force balance principle? State some of its’ advantages.
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
you are on site,the plant trips,you are approached by operations,what do you do?
how to design orifice plate?what is the equation?
