Answer Posted / chetan jodatti
instrumentation is a reading
which approach's the true
value to the measured
value is called as
instrumentation.
Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
what is the importance of CV in the control valves? how it is calculated?
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
What is Positive Calibration and Negative Calibration?
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
Explain operation of Haskel pump.
whats the abbreviation of IOP? is it instrument of power or input open problem?
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
why orfice is not used for main steam flow calculation
What are the types of control valves available
how to calibrate steam control valve in steam turbine