Why should we use jelly filled armoured cables in underground
Communication system? What is the use of the Jelly? If we go
for unarmoured, then what happens?
Answer Posted / sarmadahmed
I'm not sure but jelly is used to absorb moisture which means cable's insulation will have longer life.
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is a power factor?
How one can check the MAIN of a house wiring ?
What consists of 2 or more thermocouples to be connented series?
how calculate the electrical load for industry and office
what is mean by parallel operation of permanent magnet generators
please give some hindalco placement papers for written exam
Explain and give examples about VCB?
how to calculation increase power factor for single phase
How it can worked plc based electrical system And which type of software using.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
What is the automatic voltage regulator with servomotor?
Different types of relay fault which phase sequence??
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
what is the purpose of silicon dropper used in battery charger?