The relation between cube strength & cylinder strength
because––
- 2 Answers
- 5338 Views
- I also Faced
- E-Mail Answers
Answer Posted / amar kantak
CENTRE OF GRAVITY
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Stringer How many cm goes to landind
material used for mendrel use to bend epoxy coated rebar
What is the material consumption- cement,sand,tiles etc for Toilet dado?
How good are the Weinerberger Porotherm bricks that are being used in construction in Chennai, India. Its being used in non load bearing walls and has a compressive strength greater that 35 kg/cm^2 and a density of approx.694 - 783 kg/m3.
what is the difference between replacement of cement by groundnut shell ash
What is .Dwg?
what are the code used for residental building?
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
what pressure the NP2 class RCC pipe can sustain?
How is calculate the cube molt
if i used salt as a add mixture in concrete, then what will happen and what are the naturally available add mixtures.
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
what is the procedure involved in preparing mix design of m15 grade as per IS-10262-1982
Is it necessary to apply tack coat over the primecoat. IF not what happens.answers other than 1.to superimpose the next layer(2) to adhere the layers so as to form homogenity.
What are the causes of building collapse?
