Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prakash g.r.
In the above answer there is no reply, how the high voltage
induced in the light since the applied voltage is mere 230
v. But to energize the electrons it is required 1000 v. It
is because of choke. once the starter supplied the applied
voltage to choke it induces flux. But the starter
immediately cut the supply, the flux disturbed and produce
more flux which causes high voltage. As the quality factor
of choke is 5 it multiples the applied voltage for 5 times
and thus produce the required voltage.
| Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Describe the colour rendering properties of i) tungsten filament lamps ii) tubular fluorescent lamp
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
what is the role of transistor in Circuit?
DG cranking voltage?
Name the types of motors used in vacuum cleaners, phonographic appliances, vending machines,refrigerators, rolling mills, lathes, power factor improvement and cranes.
what is the role of energy meter in distribution system ?
how to calculate insulation level of transformer?
when will be the iocl interview results ifaced the interview on september 8 th
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
why they were using TRIAC instead relay in some controllers and what is the advantages.
why impedance relay is used for medium transmission line protection
what is the voltage rating of chiller unit sensors
why and how current drawn by battery charger depends upon the altitude where it is located?
