what r the tests on the 3 phase transformers
can any one explain how to test using megger on transformers
thx
Answer Posted / ranjan sannyasi
Many of test over an 3 phase transformer you can done, you
have to mentioned about megger test,so that test what actual
done,it's ur qsn...may i r8?
so, It's actually IR test means Insulation Resistance(IR)
test,how much insulated the transformer winding in between
their winding(primary & secondary).You could be known by
meggar test.
1.1st You have to do the PHASE TO EARTH test,how to do the
test? megger have two terminal,one of them you have to
connect with 1st phase (R-phase) or whatever(it may be
another two Y or B),must be one by one,it ds'nt matter ok,&
another with transformer body,its the earthing path.
regarding this test obtaining three of value must be
100,it's must be noted that 100 value is the accurate,if any
of value is 0 then some where in b/w winding & body it may
be leakage,for that DC current** is flowing through the
winding to earth.
2. 2nd test is the vital one.It's PHASE to PHASE TEST.It's
done by like that, suppose megger one terminal is connect R
phase and another one done by Y phase, so like that 1st R-Y,
2nd Y-B & last B-R, same you have find 3 value,like above
those.If all the value are 100 then its insulation b/w
winding are accurate,there have no insulation fault.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
Why different Pressure switch used in marine boiler water circulation system
What is the difference between multimeter
What is the basic rule for block diagram reduction technique?
i have a 1500kVA transformer what is the kWH meter i need to use?
what is the carona effects meaning in HT line transmmission system
Can you explain about Restricited earth fault protection scheme
What is the difference between DOL starter and star delta starter
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
explain wiring system
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
How to Decide(calculate) Bush bar size for copper and aluminiam ?