Interested to Buy Any Domain ? << Click Here >> for more details...
How to find the volume of wood(tree) from its height and
circumference.(circumference-6'5" and height 3'2")??
- 1 Answers
- 4372 Views
- I also Faced
- E-Mail Answers
Answer Posted / abdul rasheeth
if the wood is circular in shape then the circumference of circle is=pi*d
(circumference)6'5"=3.141*d
6'5"/3'141=d
d=2.042ft
volume=area*height
=(3.141/4*2.042^2)*3'2" (height)
therefore the wood's volume=10.365 feet^3
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
column at edge of a framed structure is uniaxial or biaxial. and is an interior column is biaxial
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
it is a corrected question." make a list of engineering property(properties) of soil.
residential buildings,mixing of concrete,structural,construction material,site handling.
How to measure the requirement of cement n sand for 12mm and 20mm plastering thanks in advance
How to find coloumn vertical cut length floor to floor & lap + bend or anything plz clearfiy
What are the steps involved in the concreting process?
What is the standard unit weight of Cast Iron pipe of 200MM Dia.(pipe specification is IS1538)
In a concrete grade C35A, C & A stands for what and equalent cube strength?
how clculate excavated or backfilling quantity by simpson's rule
how many numbers of 4inch bricks and get consumed in 9 inch BB masonary wall in cubic feet.plz send my below e.mail adress
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
what will happen if one could not properly follow the spacing of slab reinforcement bar?
How do we calculate absolute pressure?
How to find out slope footing concrete
