HOW DO I CALCULATE OVER LOAD RELAY & CONTACTOR IN DOL
STARTER?
& in dol why it is require circuit breaker?
- 6 Answers
- 20006 Views
- DLF, I also Faced
- E-Mail Answers
Answer Posted / ermias solomon
in OLrelay 115%*motor name plate current
for contactor use
NEMA table by ermias solomon
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How to Calculate The sag of OPGW in Transmission Line???
what is solkor relay and which condition it will act?
How would you relate your key competencies to this position?
How to know vacuum in vacuum cylinder of breaker in working condition
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
Is a d.c.compound motor is use as a booster? how?
TYPE'S OF BREKAR ,WHAT IS TRANSFORMAR & SAFTY. STARTER DOL & STAR DELTA STARTER.
what is effect of length of air gap on performance of dc motor and generator?
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
What are the types of windings according to the construction?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
