Answer Posted / ramarao
Mineral insulating oil / askarel
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
What is the difference between a Root Locus plot and a Bode plot?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how to Select its CORE in electrical cables based on its applications? or Application of various types of electrical cable based on it CORE?
Igfet is a
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
What is the drawback of static coefficients?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
What should be the height of basement according to NBCC code?
Mention the difference between Analogue and Digital circuit?
what is booster? and how it is connected in a circuit?
Which type of questions well asked. ?
What is the formula to calculate the rating of power cable for three phase current.
what is physical distance of isolator to VCB in 33/11kv sub stations