Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mailsamy
Switching time, construction wise
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
What is the main cause of magnetism?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
What is the physical significant of power factor?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
Atwhat condition reverse power relay will act?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
during installation time of transformer and alternator which points we have to observed?
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
What are reasond for high wattage in single phase induction motors
How to measure current and voltage in an ELV circuit
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
why you don not show protection and type of isolation in key single line diagram?
