Interested to Buy Any Domain ? << Click Here >> for more details...
How does the humidity affect in breakdown voltage of air?.
Is the breakdown voltage increases with the humidity?
- 2 Answers
- 5297 Views
- I also Faced
- E-Mail Answers
Answer Posted / dev
increases as aval of ions increse
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
what is transient voltage?
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
how to find three phase complex power in per unit and MVA?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
difference between Ac and Dc mcb ????
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
Why the arms of delta in a delta-wye power transmission system are kept constant??
how we findout a ignater is faulty or not?
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
