Answer Posted / ravi
Resistance is a term that describes the forces that oppose the flow of electron current in a conductor which is measured in units called ohms
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the power factor of an alternator at no load?
list the type of vfd? wich is sutable for heating kiln?
State ohm’s law?
For a stable system, where should the poles of a system be in a root loci plot?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
Can anyone explain me about the capacitor calculation
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Did RMU have ct and pt ?
Make a list observation on Transformer?
What will be result if we connect LT votage to the terminal of HT motor?
please send me previose rrb junior engineer qustion papers
What are marginally stable systems?
how you configure motorvision relay (L&T make)from DCS
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence