Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manish
Resistance is a factor which stop electrical current.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
why dc is used in control circuit for mv & hv switchgear instead of ac
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
On what basis the the size of Lightning arrester for buildings are selected ?
why the India electrical supply transmission loss is high when compare to us
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
What is Plank's Law?
What is the Minimum winding resistance of motors ( small & big)? referance range
Why an ac systems are preferred over dc systems?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
if we have 320KVA Genset kindly advice how much load we can put it.
