Interested to Buy Any Domain ? << Click Here >> for more details...
Explain the working principle of servomotor
- 20 Answers
- 55239 Views
- ABB, Bhel, FANUC, GE, Jindal Steel and Power, L&T, SIA, Steelco Gujarat Ltd, I also Faced
- E-Mail Answers
Answer Posted / sandy
servomechanism is a feedback closed loop control device in
which negative feedback is applied to the input through the
feedback element in this system output position is
unchanged(constant).
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What are the causes for the failures of sandwich type (Al) busducts?
Which motor connection is preferable star-delta or delta-star?
can i connect wavetrap in 2 different phase in EHV line?
what is the difference between oil surge relay and buchholz relay.
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
Why the cores of large transformers build up of circular cross section?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
can anyone provide me a amf panel control wiring using ec-2 relay?
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
what is the use of expulsition protective gap in 11Kv line.
Why neutral point is consider as zero potential?
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
