why most of the substations are rated in multiples of 11?
Answer Posted / usha singamsetty
its not multiple of 11...
its multiple of form factor=1.11
for sinusoidal wave form factor is 1.11 so it is mutilplied with 1.11
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is Load sharing of Transformer ?
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
Draw the line diagram of diffretial relay connected to transformer?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
What is primary and backup protection?
what is the use of sdf?
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
Explain the advantages and disadvantages of hydropower plant?
What is Plank's Law?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
what is ic 01,ic 06 ?is it types of cooling?