Interested to Buy Any Domain ? << Click Here >> for more details...
What is material of is 1968 and what is its modulus of
elasticity.
- 2 Answers
- 6622 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / chirag.davda83
The G (0°) value
listed in Kollmann and Côté (1968) is 745 MPa,
which was obtained using the method of March et
al.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What affect would increasing the charpy impact toughness on an object have on the surface of an object it strikes if all else remains the same? Would it cause moredamage to the object it strikes?
difference between sand casting and shell casting
what medal conducts heat best?
How do you express pitch of gears?
Explain wear resistance of titanium?
Define what is the metallurgy use? Define what is the casting and forging?
How is solution annealing carried out? What type of furnace is required? Does one need to be heat in a salt bath?
How is solution annealing carried out? Define what type of furnace is required? Does one need to be heat in a salt bath?
How is metal heavy?
On which basis annealing cycle of steel bars of UpTo 6 MTR can be decided.we r charging 40-45 metric ton load for annealing in bogie furnace?
I currently use 17-7 PH stainless which is hardened to condition CH after forming. raw matl is .1.75"X .12" X .008". Its main usage after hardening is silicon wafer retainer where it's contantly cycled up and down to putin and remove wafer after 40-60 sec process at 400C temp. At this high temperature this part seemed to deform after a a couple of hundred wafer which is what it was designed for in the first place. THere is a proposal to go to a different material to increase lifeline of this part. My question is..... can 321 SST be a plugin replacement. I know this has a higher temp rating but how about its forming characteristics, will it have spring properties, and wont become brittle after prolonged exposure to 400C.
Define what is the difference between stainless steel and alloy steel?
What are the uses of electroplating?
what is the different between ferrite percentage and ferrite number?
What is the use of gap(snap)gauge
