Interested to Buy Any Domain ? << Click Here >> for more details...
why is fan rotating slow speed, what is the problem?
- 4 Answers
- 7454 Views
- I also Faced
- E-Mail Answers
Answer Posted / ....
capacitor is week
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How two nos. 130 kw D.C motor get synchronise using D.C drive.
What is transient Phenomenon?
What is The Resistance Formula
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
How may I enrol or get admission to your program?
What do you mean by a voltage transformer?
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
what is the necessity of under ground cables ??
