Interested to Buy Any Domain ? << Click Here >> for more details...
why are set -10vdc in bently neveda vibration system.
- 4 Answers
- 7643 Views
- I also Faced
- E-Mail Answers
Answer Posted / manishahir
-ve for npn transistor and 10 for both side measure vibration ie towards the probe and opposite side of probe.so its change -10 to -24 and -10 to 0.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
How to Calibrate Ultrasonic flow Transmitter in Field
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
Why plc require in analog input 4-20amp & 0-10 volt?
How hart protocol can be connected with control valves?
What is zener diode? What is voltage regulator?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
How do you identify an orifice in the pipeline?
what is the reason while warning lamp is on while the engine is cranking?
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
