in M-20 Grade of concrete what do u mean by (M)
- 15 Answers
- 21230 Views
- GVK, I also Faced
- E-Mail Answers
Answer Posted / mittal
mix design
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
show answer/calculate mix 1:2:4 ratio -cement-sand -metal-water
Rate analysis for construction of a solid block masonary of size 400x200x200 in C.M.1:5 in superstructure .Compressive strength 5.00 N/Sq.mm Confirming to IS: 12894:1990, with necessary scaffolding, raking of joints and pointing the same. I require rate per Cum.
types of piles detail,
Prepare a Schedule for a Highrised building from starting stage to Handover?
water leak detection system question & answer
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
What is the zero value in quantity surveying
Types of column foundation and how to calculate its steel quantity.
where can i get the previous question papers for rrb section enginerr (civil)
Define What is unit weight of normal concrete?
What is the nature of duties & responsibilites senior civil engineer ?what is self confident & satisfaction should be a senior civil engineer?
Describe the sections included in a typical bill of quantities
Rate analysis of 150mm, 100mm, & 230mm thk BBM work
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
What is the difference between Grade I, II and III of GSB?
