What is the permissible value of earth resistance and as per
which standard / act / rule ?
- 3 Answers
- 5415 Views
- HBL Power Systems, I also Faced
- E-Mail Answers
Answer Posted / guest
Less than 1 Ohms.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what may the reason for vector shift in a generator?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
working principle of AC Servo Motor with its construction
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
how the characterstics of control valve being done
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
How much voltage we need to apply in 33kv cable during hipot test of cable
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
how we find transformer capacity by ohm
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
Sate maximum power transfer theorem?
A low wet bulb temperature indicates
What are the Full Forms of TVM, MTL, CVT ?
