what is the weight of 8mm dia steel with 1 meter length.
Is there any formula to calculate the weight for any given
diameter
Answer Posted / k.paul lessley valavan
Rebar Weight Formula?
Exmaple:-
There is another way of calculating the specific weight (or unit weight) of a rebar. Especially for those who are interested of rebars less than 10mm of dia.
the way is to calculate it mathematically knowing that the
Note:-
a.] Density of steel rebars is 7851 Kg/m3.
b.] 8mm Diameter Rebar
A.] Formula:-
Unit weight [Kg/m] = Cross-Sectional Area [m2] x Density [kg/m3]
B.] Answer:-
Unit weight [Kg/m] = (22/7)x(radius)2 x 7851 kg/m3
Unit weight [Kg/m] = 3.14 x 16 x 7851 kg/m3
Unit weight = 0.395 Kg/m
8mm dia 1m weight = 0.395kg
Weight of Rebar = .0395[Kg/m] x Rebar length
8mm dia 3.66m length Rebar Weight ?
= .0395[Kg/m]x 3.66 [m]
= .14457[Kg]
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
For what purpose bedding is used under storm water drains?
Which condition will prevail for the design of a swimming pool ? When the pool is empty or when it is filled ?
at what pressure ply-wood is obtained by gluing wooden sheets
Define What are the reasons for geotechnical site investigations in Uganda?
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
how to calcualate the amount of stone,cement,sand required for 1cum of 450mm thick ruble stond masonary with ratio1:5, please me an answer with dtailed step
what is density of 20mm coarse aggregate.plz send answer my below adress e.mail
CAST EFFECTIVE WATER SUMP CONSTRUCTION DETAIL
what is the max. area can we apply the plate load test ?
How to convert 20 dia bar to 16 dia bar in beam without reducing the steel weight
what is c4x light weight cement blocks
How to determine dia of steel for use in column,slab etc. i mean how to calculate the diameter of steel which is to be used in structures.
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
50 acre of land to be reclaimed for an average height of 2.5 mt. Dredging area is 500mx200m size. what is the dredging depth required to reclaim the area?
step by step procedure to find out the percentage of steel in coloum,beam,slab,footing in detailed