why we use perllel conection system in the wiring?
- 4 Answers
- 5377 Views
- Airtel, I also Faced
- E-Mail Answers
Answer Posted / rk
Possibly when any devices are connected in series wiring
connection if any fault happens in a device other devices
also gets effected, so in parallel wiring connection only
that device gets effected which have got fault.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
what is a pilot wiring and whys that called a pilot wiers
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
How to calculate Grid rotor resistance(GRR) losses in slip ring induction motor?
What do you mean by the zone of protection?
Explain mechanical rotational system?
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
how flow current in 220 kv line to line
why high speed tripping relay is used in protection circuit why not normal relay
If we want to change a contactor of faulty one what are the conditions want to fullfil
Explain the operation carried out in thermal power stations?
What is difference between start imitation and start interlock for 3 phase motor protection ?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
