why we use perllel conection system in the wiring?
Answer Posted / rajkumar
in parallel connection the input voltage is same.current various depending upon the load.(v=230)
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is a feedback in control system?
if sf6 gas low in gis what will happen
Please explain, how to test vector group of tranformer(Delta y1) . Thank
What is the range of the stator resistance of 3 phase induction motor?
What are the three constants associated with a steady state error?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
What cmos is and its benefits?
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
why servomotor motor? where i apply for best output?
What is miller crystal oscillator? Explain its operation?
in india per day how much power is generated including all power station
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
Please brief working principle & construction of permanent magnet AC Servo motor
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit