If there is unit power factor in a power house and a capacitor bank used in a factory at resistive load . In this case, will there leading power factor in power house across that factory.
- 2 Answers
- 3456 Views
- I also Faced
- E-Mail Answers
Answer Posted / prasanna raj
I dnt thnk so. Most of the loads used in power house are of Inductive only which have lagging power factor. If in case capacitors banks are used, Capacitors inspite of having leading power factor discharge & drop the power factor once the loads are connected to capacitor banks. I think it will not maintain leading power factor once capacitor banks are connected to resistive loads (in case) but will be lesser or nearer to Unity power factor.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
How to calculate ant test the burden of Current transformer
how meger function
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
Why Ac Systems Are Preferred Over Dc Systems?
What is the name of the winding from which the supply is taken for load connections?
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
What is quadrantal symmetry?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
how to deside the capacity of chock for drive?
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
