what is the function of commutator in dc motor?
- 52 Answers
- 167146 Views
- Aviation, HP, Raj Construction, TCE, University Exams, I also Faced
- E-Mail Answers
Answer Posted / ranjith
in a dc motor dc current is converted into ac as input is dc and commutator serves the purpose of both ac to dc and dc to ac
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
What is order of the system?
Define maximum demand?
What is the basic principle of operation of alternators/dc generators?
we need a ntpc previous papers
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
Explain the purpose of inductor in an electric circuit?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
defination of controlled shunt reactor
how to calculate earth fault relay current and CBCT ratio
hai...... tis is Hemanth. jst now completed electrical engineering... i wanna to apper for ap tranco exam... plzz send me the previous q's paper link......thanx in advance.
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
WHAT IS DEAD END IN PROTECTION?
