In case of 3 phase motor why it is called single phasing by failure of one phare unless there is rest two phase are acting. ?
Answer Posted / satya dev
Basically 3 Lines are connected to the motor for operation
that is known as Line1, Line2 and Line-3 or L1, L2 and
L3.and the voltage between L1-L2, L2-L3 and L3-L1 are
called Phases. During the single phasing actualy one Line
has failed so two phases will be down and one phase will be
acting thast why it is called single phasing. single
phasing means one line failed and it will resulted two
phase dead only one phase can active.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
why impudance relay used for medium transmission power system? why not others?
How it can worked plc based electrical system And which type of software using.
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
What is the comparison of PILC and XLPE cable
How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
What is the kiosk parts, about them and their functions ? If anybody have some PDFs files or details about this plz send it on tawhidfaisal@Yahoo.com
impliment (AB)`+C to transistor representation
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
How colour picturetube works & how many year it will works.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
How does a transformer contribute towards the widespread popularity of ac system over dc?
what is circuit recombiner and how it is different from circuit breaker
How to convert 2 phase to 3 phase electricpower in induction moter?