WHY HOLDING CONTACTOR OF MOTOR STARTER IS CALLED NO VOLT
COIL.
Answer Posted / sreekar
since if no volt is avialble for coil operation, it
isolates the motor from supply.
like that it protect motor from start on load when supply
resumes.
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
what parameters should we check to reduce the power bill
what is meant by motor startup supervision & motor load jam protection ?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
difference between servo motor and synchronous motor
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
bitumar
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
What is VSCF windelectrical system?
What is the effect of positive feedback on stability of the system?