Interested to Buy Any Domain ? << Click Here >> for more details...
Why we connect the capacitor in Delta?if we conect in Star
what will happen?
- 9 Answers
- 32885 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.ravindran
When connected in delta, the voltage on each capacitor will
be the phase voltage.
When connected in star, the voltage on each capacitor will
be the phase voltage divided by root of 3.
If the capacitors are rated for the available phase
voltage, then they can be connected either in delta or in
star.
| Is This Answer Correct ? | 28 Yes | 10 No |
Post New Answer View All Answers
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
any earth foult trip the relay but in welding time not trip by earth foult
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
relation between power station capacity and voltage level?
How to measure size of cable on a given load
How much dc volt applied in cathodic protection system?
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
What will be in Mahagenco Trade Test Exam? I want to know the same.
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
What is resolution of a measurement?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
What is the type of feedback used in an op- amp schmitt trigger?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
