If a line which is drawing approximatly 2100amps what
should be earthing streep size(using galwanize streep)?
Answer Posted / narsing
50mm or 60 mm of width and 6mm thicknes
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is doid
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
how we decide the require size is this for a known current at fuu load?
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
how to select proper cable for ct wiring so that drop within the limit.
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
how the inner and outer body is separated in aircrafts?
what is current check gurd relay?
how does a shunt reactor maintains the bus voltage???
Please brief what is sinewave
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
how the works electronic energy meter?
What is core CT & it's function?