what is power factor when in view of a lineman
Answer Posted / divesh devadas
This Question have a simple answer that is EFFICIENCY...
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
Why do we avoid electrical conduits in floors at apartments?
state the working of discharge lamp?
What is the use of Surge Capacitor in LAVT?
Why do we require transformer with less specific weight if supply frequency is increased?
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
define as synchronous generator
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
what are the specifications we must look at to select a relay for any capacity motor?
What is meant by bus bar protection?
Why is the frequency not changed during transformation of electrical energy in a transformer?