in case dc we mark as + ve & -ve..but in case a.c. we mark as
ph&N...Y LIKE PLZ TELL ME
Answer Posted / surendra
load safty is responsible for all these classification.. as
in case of dc there is a permanent neutral.. in ac there
should be a neutral.so that more variation in voltage we can
get..and load can get reliable voltage .........
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
Why strting torqe high in inducation motor?
how do you choose the cable size as per amps rating & the voltage drop for the same.
Why temperature rise is conducted in bus bars and isolators?
What is the instrument to check the rotating diode fuse of alternator in running conditions?
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
where was current transformer protection units used and why??
please explain to me how to calculate current,voltage,resistance with formula??
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
how to calculate
How many types of circuit loads are there in a common electrical circuit?
If we want to change a contactor of faulty one what are the conditions want to fullfil
What is the resonant peak?
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?