why hv current transformers have big size ?
- 5 Answers
- 7412 Views
- RailTel, TCS, I also Faced
- E-Mail Answers
Answer Posted / pugazhenthi
U see.. In high voltage side current
should be minimum,tat s y size must be
small not in large size.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
How to findout raw or ups power? its not indicated in socket,
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
what is the minimum winding resistance of 30hp compressor, to run or to switch on
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
i am going to give the JSEB,RANCHI exam for power plant,so i need some samples of papers related to that,so please send me these papers by my mail id.
A parallel flow heat exchanger will perform better than a counter flow heat exchanger. State if the statement is true or false.
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
how to calculate fault level?
How to detect voltage vector shifting in interconnection protection.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What is the formula to calculate distribution transformer De-rating on iron losses basis
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
