Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gopinath
the power factor in genertor is 0.86
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is voltage ratio of a transformer?
What is the relationship between voltage,current & frequency?
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
difference between ac series and parallel circuit
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
hey guys help me out.....what are the industrial uses/functions of nozzles in industries
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
how to remover corona effect and hysteresis losses from contactor
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
Is phenomenon of resonance is harmfull fr the machine? if not or if yes please explain it?
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
what is cascade speed control device?and how this device control the speed of motors?
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
