Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / niharika
Ideally power factor should be unity to have good efficiency and minimum losses.
if pf is higher than unity, current increases thereby increases losses (heat) and reduces efficiency..and may damage the conductors due to heating as current exceeds the rating value..
| Is This Answer Correct ? | 11 Yes | 12 No |
Post New Answer View All Answers
a governer in an Ic engine controls the
Differentiate between digital phase converter and ordinary phase converter.
different aspects of voltage stability
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
How many points does a Circuit can have?
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
WHAT IS counter flux IN CT?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
Tell me all plants load factors i.e which plant operating on which load?
How to calculate the sag of OPGW during stringing???
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
why we used dc supply for field in dg set
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
what are the 4 rules to start the motor?
