Most electrical terms denoted by first letter of its name
but Why current is denoted by "I".
Answer Posted / waqas sumraa
i also forced thih question
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
Where should the lighting arrestor be placed in distribution lines?
Advantage of LT panel vs HT panel
What is the operating principle of turbo-generator.
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
What happen when change order of CT in GIS feeder?
what is difference between 5A and 100A CT constructional wise and operation?
what do you mean by every IC 74 first digit.why are you using this no.why not using another no.
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
How many VSC based HVDC are there in India and the world
Why cables and busbar both needed in LT Panels?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]