Interested to Buy Any Domain ? << Click Here >> for more details...
difference between DCS @ SCADA system?
and how can use in field
- 5 Answers
- 10107 Views
- Marafiq, I also Faced
- E-Mail Answers
Answer Posted / cubes
DCS IS DONE TO AUTOMATE A PLANT. IT IS DONE WITH THE HELP OF
PLC'S AND SCADA.SCADA IS THE SYSTEM THAT PROVIDE THE
MONITORING AND CAN PERFORM ONLY PROCESS OUTPUT CONTROL.HENCE
IT IS A SUPERVISORY CONTROL.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
what are the values of fuel flow rate in various places in boiler.
how many types of preheaters are in cement industry & what r they can any body explain?
please send data bank of quetions answers on analytical instrumentation.
How hart protocol can be connected with control valves?
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
What are different types of orifice plates? State their uses.
What is force balance principle?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
What is 3 selection available when configure the burnout protection for controller
