what is difference between vaccum circuit breaker and air
circuit breaker?
Answer Posted / rameez ajmeri
rubbish...if you dont know the answer of this you better
repeat degree or diploma whatever...!!! You are not liable
for an Electrical Engineer.
Vacuum Circuit breaker uses vacuum for arc quenching where
as Air Circuit Breaker uses air for arc quenching.
if more info required...open you switchgear and protection book
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
How cmd is calculated in case of energy neters
What is servo motor and what are different types of servo motor
different aspects of voltage stability
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
why industry prefer ht motor instead of lt motor.
how to calculate single phase motor efficiency ?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What is distance between electrical panel to land ?
What descriptive information does the NEC require to be marked on all conductors?
how is control wiring coding is done in a CRP panel ?
Earth has zero potential then what would be the neutral potential ?
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?