Answer Posted / kishor deshmukh
actually the formula to calculate is expressed in terms of
the square root of change in the diffrencial pressure of the
flow at the upstream and downstream side of the dp cell so
we need to use the square root extractor.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
why we are using drum level control valve air to close?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
Calibration procedure for water rotameters
What is the use of gauge?
What is the minimum rating availalbe for weld neck orifice in market?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
how is work pressure switch& level switch?what is the principle of this?
Why not come out analog output in ABB EL3020 when display show correct value
what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.
how many type of plug are used in pneumatic control valve,name them.
how the arrangement of equipments done in control room
