Interested to Buy Any Domain ? << Click Here >> for more details...
in ONAN type transformer winding temperature is lower than oil
temperature at evening time but morning winding temp is higher
than oil temp what is the reason?
- 2 Answers
- 6737 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / raziq ulla
In ONAN type cooling,in the evening oil temperature is
accumulation of both atmospheric temperature of whole day
and winding temperature, so that temperature of the winding
In the evening is lower than oil temperature. At night due
to cool atmosphere continues till morning temperature of
the oil get down to its normal value and the volume of the
oil in a transformer is higher than the volume of the
winding so the heat generated by the winding is dissipated
by the system easily so that temperature of the winding is
higher than the oil temperature.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
who can measure the size of power cable?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
what is the working process of over & under voltage relay.
what is the difference between an alternator and a synchronous motor
rajha power sector details
induction 3 phase motor terminal connection
What is step signal?
The moisture in air will condense at
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
he compression ratio for a petrol engine generally lies between
