Interested to Buy Any Domain ? << Click Here >> for more details...
For Beam steel reinforcement detailing, in the End of the beam do the making of L shape in the rebar is essential in all the cases, specially in the ends of the Beam?
- 2 Answers
- 8712 Views
- I also Faced
- E-Mail Answers
Answer Posted / mdnahid akhtar
it is compulsory to do bend in the end rregion of beam,because the maximum chances of deflection is always near the sopport.in some cases the concrete leaves the rib of steel,called sleepage. so to avoid the sleepage and to increase more tensile strength doing bend (L) is necessary.in cantilever no discussion .but in S.S beam it may run.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
What are segregation and bleeding?
Is there the dry coefficient of cement is constant?
What is the Null Point of chimney in Power Plant
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Ratio for 4500 psi concrete
What is the crank length in the slab?
What is soil enforcement?
What is aggregate?
Which are the top apps for you civil engineer?
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
roll of DLC in road constructions
What is the material consumption- cement,sand,tiles etc for Toilet dado?
what is meant by csr in foundation? what is sbc?what is meant by contour line?
Why you are leaving present job?
What is the difference between shear and tensile strength?
