Answer Posted / gopalakrishna
transformer ratting are always in KVA or MVA why because
transformer iron losses are depen upon current, and copper
losses are depending upon voltage hence the rattings of the
trans former rattings are in 'kva'
Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What difference between ref protection and differential protection ?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
impliment (AB)`+C to transistor representation
What are dcs and plc?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
What is the relation between frequency and motor rpm?
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Which motor will you choose which can operate in both lagging as well as leading power factors?
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
how to calculate earth fault relay current and CBCT ratio
How to setting the volume of RTCC panel AVR (11kv) controller
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?